Steelflex Roller Shutters - Data Sheet


Constructed from interlocking pre-galvanised scrolled steel lath. Each alternate lath being complete with pressed steel endlock securely riveted at either end.

The curtain would also be complete with a standard pre-galvanised ‘T’ bottom
section with interlocking (EPDM) rubber seal.


Cold roled formed steel channels manufactured from 2mm gauge Z2. Pregalvanised steel to BS 2989: 1982, welded to 100mm x 65mm x 3mm
galvanised support angles.

Incorporating twin vertical brushes on both inner
and outer faces of the guide.

The guide profile is designed to allow reduced
working faces and tapered inner faces to provide automatic interlocking/retaining when fitted with wind end locks for performance under wind load.

Complete with continuous 100 x 65 galvanised fixing angle.


Manufactured from seamless mild steel tube to BS 4760 Grade 50C. Gauge to suit door width and height. Maximum barrel defelection 1:400.

Fitted with
precision machined BDMS axles to BS 970 EN933.


Fabricated from mild steel plates complete with angle support brackets to
BS 4360/43A.

Size and gauge dependant upon door size and weight
incorporating support bearings.


The door is arranged for an electric motor unit with manual hand hoisting and lowering facility.

The motor unit is complete with an in-built safety drive system.

Operating voltage 400V 3 phase IP54 protection 60% duty cycle maintenance
free and TUV tested, complying with all current European safety standards.

Opening speed 220mm per second. U value 1.4 W/M2

Technical Information
CE Mark (Declaration of conformity)
Type Approval (Chiltern Dynamics - UKAS approved test laboratory)
Mechanical Aspects EN12604, Safety in use of power operated doors
Side guide protection EN 12604: 2000 4.5.1 and EN 12453: 2000
Protection crushing, shearing or drawing in
Electrical Safety Depending on the use
Water Tightness EN 12489
Resistance to Wind Load EN 12444
Air permeability EN 12427
Opto Safety Edge Self Monitoring
EN 12453 -
Closing Forces
(Auto close only) EN 12453 -
Anti fall back device EN 12453 -
Installation Instructions EN 12635: 2002
Durability of Mechanical Performance
EN 12635: 2002
2500 2500 400 450 221 20
4000 4000 400 450 221 20
5000 5000 450 500 294 35
6000 6000 500 550 234 60
Door hood addition - Dim B + 50
All Dimensions in mm







We use cookies to improve our website and your experience when using it. Cookies used for the essential operation of the site have already been set. To find out more about the cookies we use and how to delete them, see our privacy policy.

I accept cookies from this site.

EU Cookie Directive Module Information